Webinar on demand:
Securing the devices that cannot run agents
Your OT and IoT devices cannot run agents. Most security tools still assume they can.
Watch the recording here.
Henning Solberg, Founder and CTO at IXT, sits down with Trevor Dearing, Senior Director of Industry Solutions at Illumio. Together, they unpack what actually separates OT and IoT security from IT, why SIM and 5G connectivity change the picture in OT environments, and how AI is speeding up attacks that used to take weeks.
- IoT and OT devices are not the same thing. Treating them as one creates blind spots.
- SIM and 5G connectivity remove the dependency on fixed site infrastructure OT environments cannot always rely on.
- Standard IT security assumes an agent on every endpoint. Most OT and IoT devices do not have one.
- AI is speeding up how fast attackers move once inside. Segmentation has to keep pace.
- See how IXT and Illumio give you full visibility into every device, and how to get started.
Preview: the charger that called home
One minute from the session
An EV charger was set up to reach one charging backend. When the traffic was mapped, its cellular module was also trying to reach a manufacturer's firmware server abroad. Nobody had configured that connection.
In this one-minute clip, Henning Solberg, CTO at IXT, describes what the first traffic map showed.
Go deeper: guides from this webinar
Each part of the session, written up
Securing your IoT devices: 8 lessons from IXT and Illumio
IoT vs OT security: why one plan leaves blind spots
IT vs OT security: why the endpoint model breaks on the factory floor
Why cellular is a stronger starting point for OT and IoT security
Securing EV charging networks: vendors, protocols and remote access
Securing remote water and wastewater sites over cellular
Zero Trust for IoT and OT: answers from our webinar with Illumio
Webinar takeaways: the devices you can't patch
How IXT applies this to your fleet: Zero Trust connectivity for IoT
What the video covers
Chapters and timestamps for the full 57-minute session
- 0:00 Introduction
- 1:30 IoT vs OT: why they need different security
- 4:38 Securing OT and IoT is not securing IT
- 11:26 Regulation: NIS2, Cyber Resilience Act and RED
- 16:23 AI and the speed of attacks
- 24:02 Why cellular suits OT and IoT
- 26:24 What Zero Trust means for IoT devices
- 31:31 How IXT applies Zero Trust over cellular
- 35:49 Visibility: you can't protect what you can't see
- 40:52 Use case: EV charging
- 44:56 Use case: electricity grids
- 46:14 Lateral movement explained
- 47:39 Use case: water and sewage
- 50:16 Q&A: how anomaly detection works
- 52:52 Q&A: where to start enforcing policy
- 55:43 Wrap-up
What IT security misses in OT and IoT environments.
Where OT and IoT security actually differs from IT
IoT devices connect appliances, sensors, and consumer hardware to the internet. OT devices run the physical processes behind manufacturing lines, energy grids, and critical infrastructure. The two get lumped together in most security conversations. They should not be.
OT environments cannot tolerate downtime the way IT environments can. A patch window that is routine for a laptop fleet can halt a production line. Most OT and IoT devices also cannot run agent software, so the endpoint security model IT teams rely on does not apply.
Connectivity is part of the same problem. Fixed infrastructure like Wi-Fi or wired networks is not always available, or safe to depend on, in industrial and remote environments. SIM and 5G connectivity give OT devices a consistent, carrier-grade path that does not depend on site infrastructure the operator does not control.
Henning Solberg, Founder and CTO at IXT, and Trevor Dearing, Senior Director of Industry Solutions at Illumio, walk through what actually separates OT and IoT security from IT, and why connectivity is part of the security conversation, not separate from it.
After the recording
book a demo
See what your own device traffic looks like
Let our team show you exactly where your IoT fleet is exposed.
Get a security walk-through here